Featured Post

October 2 - Meetings, Grading and Pews

Image
Another Status Meeting in the Church - A week ago Sunday the second status update meeting was held at the church. While there were some assembled pews, they were all in the sanctuary, and not in the dining hall where the meeting convened. So, everyone that wanted to sit had to bring their own chair. In the picture, Bob is standing but not because he failed to bring a chair. He wanted attention so he stood up in the front to give his status update. After Sam reported on the finances discussion ensued about whether or not to increase our self imposed debt ceiling. While the church could be 'completed' without the increase, some desired items like an epoxy sealed kitchen floor would have to be deferred. The congregation agreed to up the debt limit. Sam stated that the bank is fine with the new debt ceiling. Sam also said the projection stand in the picture is only temporary. With the current projected spending, we will still not have a completed kitchen so the eagle-eyed shoppers ...
Post a Comment

July 28 - Preparing for the Walls

For a guy that grew up watching traditional wood and masonry construction, ICF (insulated concrete form) construction is as baffling as Common Core math. Forming and pouring a concrete footing makes a lot of sense. Building  church walls out of foam, tinker toy type blocks is nothing short of amazing.

Measure, drill and plant rebar -
The footing is marked for the outside of the foam block and a center line along which the holes are
drilled for the rebar to be planted. A ring cut from a length of pvc pipe is then dropped over each vertical rebar.
Mark and Brent are indicating where to put a hole
in the wall that does not yet exist. A length of plastic
tube, about 6  inches in diameter, will allow for
wires and pipes to get into or out of the building.

















Mark Hillukka drills holes in the
the concrete.
Tim Sturos uses compressed
air to blow dirt from the holes.






Dustin and Spencer strike a pose
with their tools..


Dustin Parks squirts in the
epoxy and Spencer Karvonen
plants the rebar with a
hammer.




Brian Johnson, with the assistance of  his son
Bryce, measures and cuts the PVC
pipe rings.


Brian hauled rebar hoping to add "iron
worker" to his resume.

There are 4.2 gazillion lengths of rebar required. The rebar shortening device was in constant use, so much so that the handle kept coming off and could not be easily reattached.

The maintenance engineers puzzle over how to effectively repair the handle on the
rebar shortener. Standing are Eric Wuollet, Kevin Moll, Elias Aho and Paul Hillukka.
Lyle Makela strokes his beard while kneeling. Many possibilities were suggested but as of the time the chronicler had to leave no decision had been made. The device has been well used and worn surfaces make simple repair not possible. There remain 1.7 gazillion rebar chunks to be cut so a solution must be found. Stay tuned for further developments.












Comments

Post a Comment

Popular Posts

February 17 - Pouring the Floor, Part 2

Image
Pouring it On Sweatshirts and jackets came off as the morning wore on, the temperature rose, and that heavy concrete hose was dragged all over the church.  When I returned to the church at about 11:30 that morning, I saw the last of the concrete truck parade.  One truck was emptying its load, another was cleaning up, and a third was pulling away to return to home base. Inside was a surprise -- the floor was almost finished!  The last of the narthex, office, coat room, and mechanical room was being poured.  Here you can see the power screeding machine in action again.  The reference laser it uses can be seen in the distance, fastened high on the door jamb leading to the sanctuary, visible just above Brian's head. By now, everyone seemed to know exactly what to do and when to do it. The pump outside is controlled remotely by Jeff Wikman, via the yellow control box he's holding.  While Mark directs the hose, Jeff monitors the progress, ready to stop the pump i...
Read more

October 2 - Meetings, Grading and Pews

Image
Another Status Meeting in the Church - A week ago Sunday the second status update meeting was held at the church. While there were some assembled pews, they were all in the sanctuary, and not in the dining hall where the meeting convened. So, everyone that wanted to sit had to bring their own chair. In the picture, Bob is standing but not because he failed to bring a chair. He wanted attention so he stood up in the front to give his status update. After Sam reported on the finances discussion ensued about whether or not to increase our self imposed debt ceiling. While the church could be 'completed' without the increase, some desired items like an epoxy sealed kitchen floor would have to be deferred. The congregation agreed to up the debt limit. Sam stated that the bank is fine with the new debt ceiling. Sam also said the projection stand in the picture is only temporary. With the current projected spending, we will still not have a completed kitchen so the eagle-eyed shoppers ...
Read more

September 25 - Last Saturday: A Really Big Day

Image
Concrete Pour -  Another concrete pour, this time the sidewalks across the front and the walk under the portico. Two truckloads of mud got all the sidewalk done and half of the dumpster pad beyond the back edge of the parking lot. Sonny Johnson, Phil Johnson and Charlie Halonen from the Minneapolis congregation as well as Dale Muhonen from Rockford volunteered to help with the job. Once again, a helping hand from the neighboring congregations is greatly appreciated. It is always fascinating to watch this work - when the truck is spilling its contents, many hands and feet are required to coax the heavy goo into its desired location. Phil is shown pushing the goo around while Sonny and Dale operate the screed. After the concrete is leveled out, the bull float is used to smooth the surface. The float may reveal a spot lacking just a little material so the master adds a shovelful here and there to make sure the surface is just right. After the mix has a chance to set up a bit, the red ...
Read more